Cutter Designs
Cutter Designs
Bolt-Hook
1x - #8-10 14-16 AWG Ring Terminals
1x - Figure-of-8 Ring Hook
1x - #10-24 1 1/2” Stove Bolt
6x - #10 Washers
3x - #10-24 Full/Hex Nuts
1x - #10-24 Wing Nuts
Listed herein are the visual and printable schematics for
Forward Mounted Hook-End Cap Assembly
This end cap assembly is used with the Large Hand Held Cutter. I have re-listed the end cap assembly in this section for quick reference and ease of viewing.
The Figure-of-8 ring allows for proper positioning of the nichrome wire and easy changing. You may opt to not include the Figure-of-8 ring and just wrap the nichrome around the bolt, but will still need the remaining components.
Electrical Components
PDF available for download
Picture may not be drawn to scale, but will give you the sequencing for attaching your Stove Bolt to the end cap assembly.
A wing nut will be used at the end to allow quick removal of your spring when changing your nichrome wire.
You will need to adjust the initial placement of the most outer full/hex nut to line up the spring at the other end.